EC Sense

TB420-ES1-B2H6 Diborane Smart Gas Sensor Module

Model: TB420-ES1-B2H6

Diborane Solid-Polymer Electrochemical (4-20 mA two-wire smart module)

4-20 mA two-wire Diborane smart gas sensor module (0 – 1 ppm range), factory-calibrated with sensor self-test and intrinsic-safety design for DCS / PLC and gas detection instruments

TB420-ES1-B2H6 Diborane Smart Gas Sensor Module

The EC Sense TB420-ES1-B2H6 is a two-wire 4-20 mA smart gas sensor module built on German solid-polymer electrochemical sensing technology, designed for Diborane detection with a 0 – 1 ppm range and 0.001 ppm resolution. It converts the sensor's small current signal into a standard 4-20 mA output through a digital circuit, and can also be converted to a 40-200 mV voltage output via an external resistor, connecting directly to displays, DCS, PLC and similar systems. Selection note: Diborane is a highly toxic, pyrophoric gas with an extremely low occupational limit (ACGIH TWA 0.1 ppm). The official 0 – 1 ppm range with 0.001 ppm resolution is intended for ppm-level leak confirmation. Like silane it is a semiconductor hydride specialty gas — mount detection points low and clear of dead-air pockets.

Key Features

  • 4-20 mA standard two-wire output, 24 V DC power supply
  • Single-gas detection, pre-calibrated and ready without warm-up
  • Built-in sensor performance and lifetime self-test output
  • Sensor lifetime self-test (20 s test emitting 3.8 mA, 30 s after power-up)
  • Fault output: 3.5 mA weak signal / 3 mA sensor failure or disconnection
  • Indoor and outdoor use, sensor operating -40 ℃ to +55 ℃
  • Fast response, stable zero point without drift, anti-EMI
  • Long lifetime, anti-poisoning
  • Integrated safety protection for potentially explosive environments
  • Dust- and corrosion-resistant PCB coating, compact, RoHS approved

Typical Applications

Industrial Gas Safety MonitoringIndustrial Process Gas MonitoringGas Leakage MonitoringGas Battery Fire Safety MonitoringGas Vehicle Safety MonitoringGas Warehouse Logistics Environment MonitoringTransformer Failure and Power Chamber Environment MonitoringData Center Gas MonitoringMedical & Health Care

Calibration & Cross-Sensitivity

Every module is professionally calibrated with standard gas before shipment and the calibration data is stored in its flash chip, so it can be used without warm-up. EC Sense provides calibration software should recalibration or correction of the 4-20 mA output be required. Refer to the datasheet for the calibration gas and cross-sensitivity data.